Section 5-Wheelchair Operation; Operating The Wheelchair; Turning The Power On/Off - Invacare Pronto M94 Owner's Manual

SECTION 5—WHEELCHAIR OPERATION
SECTION 5—WHEELCHAIR
OPERATION
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Set-up/programming of the Electronic Control Unit is to be performed ONLY by a
qualified technician. The fine tuning adjustments of the controller may affect other
activities of the wheelchair. Damage to the equipment could occur under these cir-
cumstances. IF UNQUALIFIED INDIVIDUALS PERFORM ANY WORK ON
THESE UNITS, THE WARRANTY IS VOID.

OPERATING THE WHEELCHAIR

NOTE: For this procedure, refer to FIGURE 5.1.

TURNING THE POWER ON/OFF

1. To turn the power ON, perform one (1) of the following steps:
A. SPJ ™ -80 JOYSTICKS - Move the On/Off switch UP or DOWN. The switch
automatically retracts back to center position.
B. DPJ ™ JOYSTICKS - Move the On/Off switch UP to the MIDDLE or TOP position.
C. MPJ ™ JOYSTICKS - Move the On/Off switch FORWARD to the ON position.
NOTE: After turning power on, all indicators will light briefly and the display gauge will indicate
one of the following:
A. THE CURRENT BATTERY CHARGE - Information gauge shows all LED's lit or partial
LED's lit. Refer to table on previous page.
B. OUT OF NEUTRAL AT POWER UP - Information Gauge shows all LED's flashing
slowly. This occurs when the power is turned on when the joystick is out of neutral. This
feature prevents sudden and unexpected movements of the power chair.
2. Turning the power OFF can be achieved by performing one (1) of the following steps:
A. SPJ-80 JOYSTICKS - Move the On/Off switch UP or DOWN. The switch
automatically retracts back to center position.
B. DPJ JOYSTICKS - Move the On/Off switch DOWN to the OFF position.
C. MPJ JOYSTICKS - Move the On/Off switch BACK to the OFF position.
® ™
Pronto M94
WARNING
28
Part No. 1122145