Gas Conversion; Tools And Parts For Gas Conversion - KitchenAid 720-0709C Manual

To Disconnect the 20 lb LP Gas Fuel Tank:
1. Check that the burner control knobs are in the "Off" position
and the grill is cool.
2. Check that the 20 lb LP gas fuel tank is in the "Off" position. If
not, turn the valve clockwise until it stops.
3. Using your hand, turn the gas pressure regulator/hose
assembly counterclockwise to disconnect to the 20 lb LP gas fuel
tank as shown.
Hand loosen only. Use of a wrench could damage the quick
coupling nut.
A
A. Gas pressure regulator/hose assembly
B. 20 lb LP gas fuel tank
4. Place dust cap on cylinder valve outlet whenever the cylinder is
not in use. Only install the type of dust cap on the valve outlet that
is provided with the cylinder valve. Other types of caps or plugs
may result in leakage of propane.
16

Tools and Parts for Gas Conversion

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Phillip screwdriver
Pipe Wrench
Adjustable wrench
6 mm socket and
wrench or 6 mm nut driver
Parts supplied
Natural gas orifices
Parts needed
Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:
Natural gas regulator 4" W.C. (marked "Natural Gas
Regulator")
10 ft (3.0 m) Natural gas hose with quick connector
5.9" (150 mm) Natural gas regulator hose
B
6 mm nut driver
6 mm wrench
Hex key
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas supply
to the appliance.
Use a new CSA International approved "outdoor"
gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.

GAS CONVERSION

Thin flat-blade
screwdriver
Pliers
Pipe thread sealant
certified for LP gas
WARNING
Explosion Hazard