Conversion From Lp Gas To Natural Gas; Make Gas Connection - KitchenAid 740-0781K Installation Instructions And Use & Care Manual

Built-in outdoor grill
Table of Contents

Advertisement

Available languages

Available languages

Conversion from LP Gas to Natural
Installation of the regulator
1.
Turn off all burner control valves.
2.
Turn off the main gas supply valve.
3.
Disconnect 20 lb LP gas fuel tank (if present) and remove
the 20 lb LP gas fuel tank from the grill cabinet.
4.
Use a Phillips screwdriver to remove the 2-piece 90º
clamp mounting bracket from the cabinet wall.
A
B
A.
4 screws
B.
2 piece 90º clamp mounting bracket
5.
Use an adjustable wrench to remove the LP gas pressure
regulator/hose assembly from the 90º brass adapter.
A
B
C
A.
Flexible gas hose from grill
B.
90º brass adapter
C.
LP gas pressure regulator/hose assembly
6.
Install the Natural gas pressure regulator onto the flexible
gas hose from the grill.
7.
Check that the Natural gas pressure regulator is
positioned under the grill (as shown in the following
illustration) and is not pinched or kinked.
Use 4 screws to attach the Natural gas pressure regulator
to the back of the enclosure.
† ®TEFLON is a registered trademark of Chemours.
Gas
A
B
A.
Natural gas pressure regulator
B.
Four 5/32" x 10 mm truss head screws

Make Gas Connection

1.
Before making any connections, check to ensure the
natural gas inlet pressure falls between the allowable
range of 7" W.C. / 0.25 psi and 14" W.C. / 0.5 psi. If the
NG inlet pressure does not fall within this range, contact
your local gas supplier.
2.
A combination of pipe fittings must be used to connect the
grill to the existing gas line.
The 10 ft (3.0 m) PVC flexible gas supply hose design
certified by CSA must be used.
Pipe-joint compounds suitable for use with Natural
gas must be used. Do not use Teflon
There must be a certified manual shut-off valve in the
gas supply line near the grill for easy access.
3.
Connect the brass connector on one end of the 10 ft (3.0
m) PVC flexible gas supply hose to the Natural gas
pressure regulator (A).
4.
Connect the quick connector on the other end of the 10 ft
(3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe (B).
A
B
A.
B.
14
®†
tape.
Brass connector
Quick connector

Advertisement

Table of Contents
loading

This manual is also suitable for:

750-0781k

Table of Contents