3. Reinstall the batteries that were removed during the lay-up, and reconnect the battery cables, making
sure the terminals are clean and that the connections are tight. Check to make sure that the batteries are
fully-charged.
4. Check the condition of the zinc anode in the sea water circuit and clean or replace the anode as needed.
Note that it is not necessary to flush the antifreeze/fresh water solution from the sea water coolant sys-
tem. When the engine is put into operation, the system will self-flush in a short period of time with no ad-
verse affects.
5. Start the engine in accordance with procedures in the "PREPARATIONS FOR STARTING" section of this
manual, page 32.
Westerbeke Generators
78