Table of Contents
Advertisement
c.
Insert the distributor shaft by turning it, ensuring that the
distributor shaft fits into the groove on the rear end of the
camshaft.
This groove is offset so the distributor can only
be installed correctly to the camshaft.
34. Adjust engine timing according to specifications
in the Engine
Technical Data Section.
35. Adjust the valve clearance.
a.
Adjust
the
valves
exhaust
#1 and #3 and intake #1 and
#2 with the piston at the
top
dead
center
of
the
compression stroke of No.
1
cylinder. .
b.
Rotate the crankshaft 360·
and
adjust
the
remaining
valves.
Valve side
Cam side
36. Thermostat.
Intake valve
0.25
mm
(0.010 in)
0.18
mm
(0.007 in)
NOTE:
Be sure to position the
thermostat with the bleed hole
at
12
o' clock.
Insure
ther-
mostat
body
is
inboard of
the
block.
Install the thermostat
housing.
36. Oil filter.
NOTE:
Apply engine oil
sparingly
to the o-ring of
an
oil
filter
and
tighten
the
filter fully by hand.
57
Exhaust valve
0.30
mm
(0.012 in)
0.23
mm
(0.009 in)
Hide quick links:
Advertisement
Table of Contents
