Table of Contents
Advertisement
3. Reinstall the batteries that were removed during the lay-up, and reconnect the battery cables, making
sure the terminals are clean and that the connections are tight. Check to make sure that the batteries are
fully-charged.
4. Check the condition of the zinc anode in the raw water circuit and clean or replace the anode as
needed. Note that it is not necessary to flush the antifreeze/fresh water solution from the raw water
coolant system. When the engine is put into operation. the system will self-flush in a short period of time
with no adverse effects. It is advisable to, as either an end of season or recommissioning service to inspect
the area that the zinc is located at in the heat exchanger and clear any and all zinc debris from that area.
5. Start the engine in accordance with procedures in the "PREPARATIONS FOR STARTING"section of
this manual.
REMOTE LUBE OIL FILTER KIT
PN#040078
This kit allows you to remove the filter off the engine and with the mounting bracket contained in the kit,
mount the filter on an adjacent bulkhead for clean, easy servicing.
Contact your local dealer for
information on purchasing this kit.
l..Ui..I!.II1!
'U
Til R
Ii
,I,
ElL!!.
GASKET CQHI6CJS BAse
73
'1.1!ll.01i..:.
.tiQIf
THe 1 oeAl! Oil
Of
TU! S
WIlliG
I f
BEHoyED fOp
lJi..S.IAI!AJ1QIi
,!,pr! r
QJ!
TO Q-R IIIG
illlllf1i......l1..i..8.Ii......A£.ll
GASKET CONTACTS BASE
WESTERBEKE GENERATORS
Advertisement
Table of Contents
