Westerbeke 7.6 KW BTD 60Hz Operator's Manual page 18

Marine diesel generator set
Table of Contents

Advertisement

Rigging and Lifting
The generator is fitted with lifting eyes. Rope or chain slings capable of supporting the generator's weight
should be attached to the eyes and the generator lifted by means of tackle attached to these slings. Th
lifting eyes have been designed to carry the full weight of the generator; therefore, auxiliary slings are not
required or desired.
II
CAUTION
II
Slings must not be so short as to place significant stress on the generator's lifting eyes.
Strain placed on the generator's lifting eyes by the lifting sling must not be in excess of
10° from the vertical pain.
ENGINE
SLING LIFTING
ANGLE SHOULD BE
AS SMALL AS PDSSIBLE
LIFTING
EYE
The general rule in moving generators is to see that all equipment used is amply strong and firmly fixed
in place. Move the engine a little at a time and see that it is firmly supported. Eliminate the possibility of
accidents by avoiding haste. Do not lift the generator by its crankshaft position. Certain situations exist
by which the engine must be lowered endwise through a small hatchway which cannot be made larger.
Under these conditions, if the opeuingofthe hatchway is extremely small, it is possible to reduce, to some
e,,"(ent, the outside dimensions of the generator by removing external components such as the cooling
system's accessory equipment should be removed by a competent mechanic and special care should be
taken to avoid damage to any exposed parts. In addition, be careful not to allow dirt from entering any
opeuing created by the removal of equipment. Removed parts should be returned to their respective
position once the generator is in its installation area. Replace gaskets as needed for the parts that were
removed.
In case it becomes necessary to hoist the generator front-end upwards or generator-end upwards, the
attachment of lifting slings must be done carefully to avoid the possibility of damaging the parts on
which the weight of the slings may bear. Special rigging work is best done by someone experienced and
competent in handling heavy machinery.
WESTERBEKE GENERATORS
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

5.7 kw btd 50 hz

Table of Contents