Handbrake On; Maserati Code - Maserati Spyder Owner's Manual

Front brake pads worn/
brake fluid low
It switches on when the front
brake pads reach the wear limit or the
brake fluid level drops below the
minimum level. The operation of the
warning light can be checked by
pressing the button on the brake fluid
reservoir cover located in the engine
compartment.
3
WARNING When replacing the front
brake pads, also check the rear brake
pads for wear.
If the warning light comes on
when the car is travelling
check immediately brake fluid
level. If fluid level is below the
minimum limit there could be a
leakage. Contact the Maserati Service
Network before restarting the car.
56 Indicators and warning lights

Handbrake on

The warning light flashes
when the handbrake is
operated.

Maserati CODE

When the ignition key is
turned to the MAR position,
it may switch on under three possible
conditions:
– One flash - key code recognised. The
engine can be started.
– Fixed light - key code not recognised.
To start the engine, follow the
emergency starting procedure as
specified in the chapter "emergency
situations", after having attempted
to start it with other keys.
– Flashing light - vehicle not protected
by the Maserati CODE. The engine
can, however, be started but, contact
the Maserati Service Network as
soon as possible because the car is
not protected against attempts at
theft.
Seat belts
It switches on when the
driver's seat belt is not
fastened or fastened incorrectly. A
buzzer is also activated for 8 seconds
when the light is on.
Passenger's airbag
deactivated (European
version only)
This warning light turns on when the
passenger's airbag is deactivated.
Fuel shut-off inertia
switch on
It switches on when the
inertia switch has been activated
following a collision, thereby shutting
off the fuel supply.
After impact, if fuel is smelt or
leakage is noted from the fuel
system do not re-activate the
switch in order to prevent the risk of
fire.