Handbrake On; Maserati Code - Maserati GranTurismo Coupe Owner's Manual

Front brake pads worn/
brake fluid low
Switches on when the front
brake pads reach the wear limit or the
brake fluid level drops below the
minimum level. The operation of the
warning light can be checked by
pressing the button on the brake fluid
reservoir cover located in the engine
compartment.
3
When replacing the front brake pads,
also check the rear brake pads for
wear.
If the warning light comes on
when the car is travelling
immediately check brake fluid
level. If fluid level is below the
minimum limit there could be a
leakage. Contact your Authorized
Maserati Dealer before restarting the
car.
52 Indicators and warning lights

Handbrake on

The warning light flashes
when the handbrake is
operated.

Maserati CODE

When the ignition key is
turned to the MAR position,
it may switch on under three possible
conditions:
– One flash - key code recognized. The
engine can be started.
– Fixed light - key code not recognised.
To start the engine, follow the
emergency starting procedure as
specified in the chapter "emergency
situations", after having attempted
to start it with other keys.
– Flashing light - vehicle not protected
by the Maserati CODE. The engine
can, however, be started but, contact
your Authorized Maserati Dealer as
soon as possible because the car is
not protected against attempts at
theft.
Seat belts
Switches on when the driver's
seat belt is not fastened or
fastened incorrectly. A buzzer is also
activated for 8 seconds when the light
is on.
Fuel shut-off inertia
switch on
Switches on when the inertia
switch has been activated following a
collision, thereby shutting off the fuel
supply.
After impact, if you smell fuel
or leakage is noted from the
fuel system do not re-activate
the switch in order to prevent the risk
of fire. Contact your local Authorized
Maserati Dealer immediately.