Maserati Spyder Owner's Manual page 156

– Open the compressor cover and take
out the pipe with the pressure gauge
H and the electric wire L with the
power plug.
– Unscrew the spare wheel's valve cap
and screw down the union M for the
inflating pipe on the valve.
– Open the cap of the power plug P,
housed in the right hand side of the
luggage compartment, and insert
the connection L.
– Turn the ignition key to MAR to
supply power to the plug and
activate the compressor pressing
switch N.
6
N
L
156 If a tire gets a puncture
– Stop the compressor when the
pressure indicated on the pressure
gauge H is 2.5 bar (250 kPa – 35 P.S.I.)
and screw the valve cap.
WARNING We recommend to check
the tire pressure on the gauge when
the compressor is off, in order to have
a preciser reading.
WARNING Do not activate the
compressor for over 20 minutes: risk of
overheating! The compressor has been
designed for inflating the spare wheel
only; do not use it to inflate
mattresses, rubber boats etc.
M
P
H
WARNING Power is supplied to the
current plug only when the key is
turned to MAR and it can only be
connected to devices with a power
absorption of 15A maximum (180W
power). Do not connect devices with a
higher power absorption to the
current plug. A prolonged power
absorption can discharge the battery,
preventing the engine from being
started once again.
– Fit the bushing E onto the wrench D
and slacken the 5 fastening studs on
the wheel to be replaced by about
one turn.