Maserati Spyder Owner's Manual page 134

Storing a speed
Turn switch A to the ON position and
reach the desired speed of the vehicle
in a normal manner. Turn the ring nut
B to (+) for at least three seconds and
then release it. The car speed is saved
and the accelerator pedal can then be
released.
The car will proceed at the constant
speed stored in the memory until the
brake pedal is pressed.
If necessary, (for example, to pass
another vehicle), you can accelerate by
simply pressing the accelerator pedal.
Afterwards, when you release the
accelerator pedal, the car will return to
the speed saved previously.
5
134 Constant speed control (Cruise Control) (optional)
Restoring the speed stored in the
memory
If the device has been switched off
after braking, the speed saved
previously can be restored as follows:
– accelerate gradually until you reach
a speed close to the one stored in the
memory;
– engage the gear selected when the
speed was saved in the memory (4
th th
5 or 6 gear)
– press the pushbutton C (RCL).
Increasing the speed stored in
the memory
The speed stored in the memory can be
increased in two ways:
– by pressing the accelerator and then
saving the new speed reached (turn
the ring nut B for more than three
seconds)
or
th
,
– by turning ring nut B temporarily to
position (+): Each pulse transmitted
by the ring nut will originate a slight
increase in speed (about 1 km/h),
whereas constant pressure will cause
a continuous increase in speed.
When ring nut B is released, the new
speed is automatically stored in the
memory.