Engine Coolant; Power Steering Fluid - Maserati Spyder Owner's Manual

Engine coolant

When the engine is very hot,
do not remove the cap from
the pan: risk of burns!
To gain access to the pan, remove the
right-hand panel of the engine
compartment, following the
instructions contained in the section
"Engine compartment panels".
The fluid level must be checked when
the engine is cold, and it must fall
between the MIN and MAX references
marked on the pan.
If the level is too low, slowly pour the
prescribed fluid through the filler
neck, until the level is close to the MAX
reference mark.
8
202 Level checks
Windshield/headlight washer
fluid
For topping up, open the cap E, pull
out the filler extension and pour in a
mixture of water and detergent fluid
in the percentages indicated on the
product box.
WARNING If the temperature is below
–20 °C, use pure detergent fluid.
WARNING Do not drive with the
windshield washer reservoir empty:
the action of the washer is essential for
improving visibility.
E
MAX MAX
MIN MIN

Power steering fluid

WARNING Make sure that the power
steering fluid does not come in touch
with the engine hot parts as it is
flammable.
To gain access to the reservoir, remove
the LH panel of the engine
compartment following the
instructions contained in the section
"Engine compartment panels".
With the car on a level ground and the
engine cold, check that the fluid level
corresponds with the MAX notch on
the tank cap dipstick.
To carry out the check, unscrew the
cap, clean the dipstick, tighten the cap
back, remove it again and check the
level.
MAX MAX