Specifications - Drill Master 69230 Owner's Manual

Specifications

Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its "OFF" position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
Insert the four Rubber Feet into the molded openings on the bottom of the Base.
Installing the Upper Blade Guard
1. The Riving Knife which holds the Upper
Blade Guard is installed through a slot
from beneath the Table Insert. Unthread
the three screws holding the Table Insert
in place and remove the Table Insert.
Page 8
Electrical Rating
Motor No Load Speed
Arbor Size
Max. Accessory Diameter 4-1/2"
Bevel Cut
Maximum Depth of Cut
Blade Type
Bolt hole for
Riving Knife
Figure 1
For technical questions, please call 1-800-444-3353.
120V~ / 60Hz / 4.1A
5,300 RPM
5/8"
45°
7/8" @ 90°
Diamond (sold separately)
E180772
Slot on Table Insert for Riving Knife
Item 69230