Drill Master 69230 Owner's Manual page 11

Tool Set Up (cont.)
3. Use the Pin Wrench and standard Wrench to loosen
and remove the Nut and Outer Flange. Remove the old
blade if needed. Do not remove the Inner Flange.
4. Slide the Blade onto the Spindle, then slide the Outer
Flange in place and tighten with the Nut, Pin Wrench and
standard Wrench.
5. Replace the Lower Blade Guard making sure that the Guard
fits correctly in place with the front edge in the slot on the
front side of the Blade.
6. Secure in place at the rear upper corner with the Washer
and Screw.
Item 69230 For technical questions, please call 1-800-444-3353.
Inner Flange
Spindle
Figure 7
Outer Flange
Slide Lower Blade
Guard into Slot
Figure 8
Blade
Pin Wrench
Nut
Wrench
Secure in place
Page 11