Specifications; Instructions For Putting Into Use - Drill Master 3733 Set Up And Operating Instructions Manual

SpEcIFIcATIOnS

Blade Diameter
(Blade Not Included,
Sold Separately)
Arbor Diameter
Maximum Cutting
Capacity
Electrical Requirements 120 V~ / 60 Hz
Tilting Head
Blade Rated Speed
unpAcKIng
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
InSTRucTIOnS FOR
puTTIng InTO uSE
Read the EnTIRE IMpORTAnT
SAFETY InFORMATIOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
FROM AccIdEnTAL
OpERATIOn:
Turn the power Switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: The Tile Saw features a built-in
water supply that keeps its Tile Saw
Blade cool, reduces dust and debris,
SKU 3733 For technical questions, please call 1-800-444-3353.
4"
(67113 4" Continuous
Rim Diamond Blade
Recommended)
5/8"
1-1/16"
22.5° to 45° Bevel
4480 RPM
TO pREVEnT
SERIOuS InjuRY
and is easy to clean. Its efficient
design returns water directly to the
reservoir and is accurate enough for
most ceramic tile, quarry tile, marble,
terra cotta, and slate jobs.
ASSEMBLY
To Install The 4" Diamond Tile Saw
Blade:
1. WARnIng! Make sure the power
Switch (4) of the Tile Saw is in its
"OFF" position and its power cord
(11) is unplugged from the electri-
cal outlet prior to performing any
assembly.
2. Remove the Screw (16) that holds
the Table (1) in place and left the
Table until the three catches at its
midsection clear the Table's under-
side. Then remove table complete-
lyh. (See Figure 2, next page.)
3. Remove the Nut (37) attached to the
Motor (32) arbor. Then remove the
Outer Flange (36). See Figure 3,
next page.)
4. WARnIng! Install Blade (67113 4"
continuous Rim diamond Blade
is sold separately) with directional
arrow visible from Water Tray side.
Slide Blade in and up from the under-
side slot in the Table, then over arbor
and rear hub flange. (See Figure 3.)
5. Attach Outer Flange and secure Nut
over arbor. Turn Nut clockwise until
tight. Do not overtighten. (See Fig-
ure 3.)
6. Disconnect Guard Stand (24) from
Guard Assembly. Slide Stand's
unthreaded end through slot under
Page 12