Character Entry - Kenwood TM-V71A Instruction Manual

chArActEr ENtry

Certain menus require you to enter characters, such as the power on message
and memory names. When character entry is required, a cursor will appear on
the display.
1 Press the Tuning control.
• The cursor will blink.
2 Rotate the Tuning control to select your desired character.
• You can enter characters as described below:
- Power on message, memory name, and repeater ID (K type only): 0 ~ 9, A ~ Z,
-, /, @, and space
- DTMF memory code: 0 ~ 9, A ~ F, and space
- EchoLink memory code: 0 ~ 9, A ~ F
- Memory group link and wireless remote ID (K type only): 0 ~ 9
3 Press the Tuning control to set the selected character.
• The cursor will move to the next digit.
• You can move the cursor to the left or right by pressing [REV] ( ) or [LOW] ( ).
• You can delete the selected character by pressing [PF1] (CLR).
4 Repeat steps 2 and 3 to enter the remaining characters.
• Press [F] (ESC) at any time to exit Menu mode.
• Press [TONE] (BACK) at any time to cancel the Menu setup and return to the Menu
selection.
24