External Ports - Fujitsu D2619 Technical Manual

Features
3.7.1

External ports

4
1 2 3
Figure 9: External ports of the system board D2619
1 Identification LED (blue)
2 CSS LED (yellow)
3 Global Error LED (red)
4 serial interface 2
5 serial interface 1
The serial interface COM1 can be used as default interface or to communicate
with the iRMC.
LAN connectors
On this system board you will find three LAN controllers: two Gigabit LAN
controller (Intel 82575EB) and a service LAN controller.
The Intel Dual Port Gigabit LAN-Controller 82575EB supports the transfer rates
of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s. The Service LAN controller supports the
transfer rates of 10 Mbit/s and 100 Mbit/s.
The LAN controllers support WOL function through Magic Packet™.
It is also possible to boot a device without its own boot hard disk via LAN. Here
Intel PXE and iSCSI boot is supported.
The service LAN port serves as management interface and is prepared for
RemoteView.
The LAN connectors are equipped each with two LEDs (light emitting diode)
indicating the transfer rate and the activity.
D2619 (RX/TX300 S5)
5 6
Technical Manual
Interfaces and connectors
7 8
6 VGA port
7 USB- port
8 service LAN port
9 system LAN port 2
10 system LAN port 1
9 10
31