Fujitsu D2542 Tehnical Manual

System board for rx100 s5

Advertisement

System Board D2542
for RX100 S5
Technical Manual
Edition November 2009

Advertisement

Table of Contents
loading

Summary of Contents for Fujitsu D2542

  • Page 1 System Board D2542 for RX100 S5 Technical Manual Edition November 2009...
  • Page 2 Gesellschaft für Technik-Dokumentation mbH www.cognitas.de Copyright and Trademarks Copyright © 2007 Fujitsu Siemens Computers GmbH. All rights reserved. Delivery subject to availability; right of technical modifications reserved. All hardware and software names used are trademarks of their respective manufacturers.
  • Page 3: Table Of Contents

    Replacing the lithium battery ....27 Abbreviations ....... 29 Technical Manual D2542 (RX100 S5)
  • Page 5: Introduction

    Introduction This technical manual describes the system board D2542, which is equipped ® with one Intel processor. Further information about drivers is provided in the readme files on the hard disk, on the supplied “ServerStart“ or “Update“ CDs. You will find further information in the BIOS description.
  • Page 7: Important Notes

    Information on which system expansions are suitable can be obtained from the customer service centre or your sales outlet. The warranty expires if the device is damaged during the installation or replacement of system expansions. Technical Manual D2542 (RX100 S5)
  • Page 8 Incorrect replacement of lithium battery may lead to a risk of explosion. The batteries may only be replaced with identical batteries or with a type recommended by the manufacturer. It is essential to observe the instructions in chapter “Replacing the lithium battery”. Technical Manual D2542 (RX100 S5)
  • Page 9 Place all components on a static-safe base. You will find a detailed description for handling ESD components in the relevant European or international standards (EN 61340-5-1, ANSI/ESD S20.20). Technical Manual D2542 (RX100 S5)
  • Page 10: Ce Certificate

    Never use sharp objects (screwdrivers) for leverage. CE Certificate The shipped version of this board complies with the requirements of the EEC directive 2004/108/EC "Electromagnetic compati- bility". Compliance was tested in a typical PRIMERGY configuration. Technical Manual D2542 (RX100 S5)
  • Page 11: Environmental Protection

    Cd Cadmium Hg Mercury Pb Lead Notes on labeling plastic housing parts Please avoid attaching your own labels to plastic housing parts wherever possible, since this makes it difficult to recycle them. Technical Manual D2542 (RX100 S5)
  • Page 12 You will find further information on this at www.fujitsu-siemens.com/recycling. For details on returning and reuse of devices and consumables within Europe, refer to the “Returning used devices” manual, or contact your Fujitsu Siemens Computers branch office/subsidiary or our recycling centre in Paderborn: Fujitsu Siemens Computers...
  • Page 13: Features

    Features Overview There are two versions of the system board D2542 with the part numbers S26361-D2542-A10 (SAS version) and S26361-D2542-B10 (SATA version). The two versions differ in the chipset and connectors assembling. Processors ® – One Intel Xeon processor, Quad Core, Dual Core or Single Core or a Conroe-L Single processor with 800/1066/1333 MHz Front Side Bus, socket –...
  • Page 14 1x RJ45 service LAN port Internal connectors – SATA System Board: 3 serial SATA SAS/SATA BP LED Front panel Reset – SAS System Board: 1 serial SATA 1 SAS SAS/SATA BP LED Front panel Reset Technical Manual D2542 (RX100 S5)
  • Page 15 Battery in holder for recycling Form factor – 260 mm x 305 mm CSS (Customer Self Service) This system board supports the CSS functionality. You will find a description of CSS functionality in the operating manual of your server. Technical Manual D2542 (RX100 S5)
  • Page 16 (e.g. drive encryption using Windows Bitlocker Drive Encryption). The TPM is activated via the BIOS system (for more information, refer to the Fujitsu Siemens Computers BIOS manual). CAUTION! – When using the TPM, note the program descriptions provided by the third party manufacturers.
  • Page 17: Main Memory

    DIMM2A DIMM1B DIMM2B 1 x memory module 2 x memory modules 3 x memory modules Table 3: Basic configuration with 1 memory module and 1, 2 or 3 additional memory modules Already populated by basic configuration. Technical Manual D2542 (RX100 S5)
  • Page 18: Pci Bus

    The following tables show an overview of the PCI slots: PCI bus Signal Slot no, Length level PCI-E x8 1x low profile or standard slot, max. length 175 mm PCI-E x8 1x low profile slot, max. length 170 mm Technical Manual D2542 (RX100 S5)
  • Page 19: Screen Resolution

    Measurement of the processor temperature, of the system board temperature, measurement of the ambient temperature by a temperature sensor. Fan monitoring Fans that are blocked or sticky are detected. Fan control The fans are regulated according to temperature. Technical Manual D2542 (RX100 S5)
  • Page 20 Voltage monitoring When voltage exceeds warning level high an alert will be generated. System Event Log (SEL) All monitored events of the system board are recorded in the System Event Log. Technical Manual D2542 (RX100 S5)
  • Page 21: Leds

    LED s A, B, C, D, E and F are visible from outside on the rear of the server. LED A and LED B are different functionalities of the same LED and are glowing diffe- rently. All the other LEDs are only visible, if the cover of the server has been opened. Technical Manual D2542 (RX100 S5)
  • Page 22 F - CPU orange CPU failure G - Controller orange controller failure If the server has been powered off (power-plugs must be disconnected) it is possible to indicate the faulty component by pressing the indicate CSS button. Technical Manual D2542 (RX100 S5)
  • Page 23: Interfaces And Connectors

    Battery DIMM1A DIMM2A DIMM1B DIMM2B indicate button Figure 5: Schematic view of the system board D2542 1 = SATA 2 connector (only for 11 = SATA 1 connector (only SATA SATA version) version) 2 = power supply for I 12 = System fan 3...
  • Page 24: External Ports

    19 = slot for riser card version) 10 = ODD SATA 5 3.7.1 External ports Figure 6: External ports of the system board D2542 1 = CSS LED (yellow)/ 6 = VGA connector Global Error LED (red) 2 = service LAN connector...
  • Page 25 Figure 7: LAN connector LAN connection LAN link/activity green no LAN connection flashing LAN transfer LAN transfer rate transfer rate 10 Mbit/s (or no connection) transfer rate 100 Mbit/s green transfer rate 1000 Mbit/s yellow Technical Manual D2542 (RX100 S5)
  • Page 26: Settings With Jumpers

    Settings with jumpers The system board is supplied with all jumpers set on the following positions. Figure 8: Jumper default settings JP8 - Boot Block Normal boot (default) BIOS recovery JP5 - Password Skip Disable (default) Enable Technical Manual D2542 (RX100 S5)
  • Page 27: Replacing The Lithium Battery

    Ê Press the locking spring into direction of the arrow (1), so that the lithium battery jumps out of its socket. Ê Remove the battery (2). Ê Insert a new lithium battery of the same type into the socket (3) and (4). Technical Manual D2542 (RX100 S5)
  • Page 29: Abbreviations

    Automatic Server Recovery and Restart Advanced Technology Attachment Battery Backup Unit BIOS Basic Input Output System Baseboard Management Controller CMOS Complementary Metal Oxide Semiconductor COMmunication port Customer Replaceable Unit Customer Self Service Central Processing Unit Technical Manual D2542 (RX100 S5)
  • Page 30 Dynamic Random Access Memory Error Correction Code EEPROM Electrical Erasable Programmable Read Only Memory EPROM Erasable Programmable Read Only Memory EMRL Embedded RAID Logic Electrostatic Discharge EVRD Enterprise Voltage Regulator Down Fully Buffered DIMM Hard Disk Drive Technical Manual D2542 (RX100 S5)
  • Page 31 Intelligent Organization Of PCI IPMB Intelligent Platform Management Bus IPMI Intelligent Platform Management Interface iRMC integrated Remote Management Controller Local Area Network Light Emitting Diode Memory Controller Hub Multi Processor Specification Non Maskable Interrupt Network Operating System Technical Manual D2542 (RX100 S5)
  • Page 32 Operating System Peripheral Components Interconnect Prefailure Detection and Analyzing Programmed Input Output Programmable Logic Device POST Power-On Self Test PS(U) Power Supply (Unit) Puls Wide Modulation Preboot eXecution Environment RAID Redundant Array of Inexpensive Disks Technical Manual D2542 (RX100 S5)
  • Page 33 SCSI Small Computer Systems Interface SDDC Single Device Data Correction SDRAM Synchronous Dynamic Random Access Memory SHDG Server Hardware Design Guide SHPC Standard Hot Plug Controller System Management Bus Server Management Mode Symmetrically Multi Processing Technical Manual D2542 (RX100 S5)
  • Page 34 Abkürzungen Trusted Platform Module UHCI Unified Host Controller Interface Universal Serial Bus Video Graphics Adapter Voltage Regulator Down Voltage Regulator Module Wired for Management Wake up On LAN Technical Manual D2542 (RX100 S5)

Table of Contents