14
Inside of cart, connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the
electronic ignition module. Total (5) connections. Connect the two wires {(a) and (b)} from the switch wiring harness into the
back of the electronic ignition module. Total (2) connections, shown A.
Unscrew the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with
the nut, shown B.
Insert AA battery into ignition module, negative (
A
(a)
3
4
5
(b)
NOTE: Switch terminals are larger than electrode
terminals and should only be installed in
location shown as (a), (b).
15
Under sideburner shelf, attach sideburner ignitor wire to electrode, shown A. Place sideburner grate onto sideburner shelf,
aligning grate legs with holes in shelf, shown B.
A
Sideburner Ignitor Wire
22
wire
1
2
Electrode
–
) end first. Then put on the cap, shown C.
ignition module
C
Electronic
Right side panel
Nut
-
+
AA battery
Sideburner grate
B
Cap
B