Removing The Bluetooth Assembly; Replacing The Bluetooth Assembly - Dell Studio XPS 7100 Service Manual

Back to Contents Page
Bluetooth Assembly
Dell™ Studio XPS™ 7100 Service Manual
Removing the Bluetooth Assembly
Replacing the Bluetooth Assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
Removing the Bluetooth Assembly
1. Follow the instructions in Before You
2. Remove the computer cover (see
3. Remove the front bezel (see
4. Disconnect the Bluetooth® assembly cable from the system board connectors, PWRSW1 and F_USB4 (see
5. Press in on the tab as shown in the illustration and pull the Bluetooth assembly away from the front panel.
6. Carefully slide and remove the Bluetooth assembly cable through the slot in the front panel.
1 Bluetooth assembly
3 Bluetooth assembly cable
7. Set the Bluetooth assembly aside in a secure location.
Replacing the Bluetooth Assembly
1. Follow the instructions in Before You
Begin.
Removing the Computer Cover).
Removing the Front Bezel).
2 Bluetooth assembly tab
4 front panel
Begin.
System Board Components).