Configuring Quality of Service
WAN QoS Profiles
STEP 1
Cisco RV220W Administration Guide
The RV220W provides configuration for Quality of Service (QoS) features, such as
bandwidth profiles, traffic selectors, and traffic meters. It contains the following
sections:
•
WAN QoS Profiles, page 149
•
Profile Binding, page 151
•
CoS Settings, page 153
Use the QoS > WAN QoS Profiles page to enable Quality of Service (QoS)
features on traffic flowing from the secure network (LAN) to the insecure network
(WAN). You also can configure QoS profiles. Profiles are used to limit the
bandwidth that is available for different types of traffic. For example, you can
ensure that sufficient bandwidth is available for your SIP voice traffic while limiting
the amount of bandwidth that is consumed by web browsing.
To open this page: In the navigation tree, choose QoS > WAN QoS Profiles.
In the Global Settings section, enter these settings:
•
WAN QoS—Check the Enable box to enable QoS features, or uncheck the
box to disable these features.
•
WAN QoS mode—Choose one of the following options:
-
Priority—This option lets you allocate a percentage of the total WAN
(Internet) bandwidth to traffic based on the priority class.
-
Rate Limit—This option lets you allocate the minimum bandwidth
bandwidth rate for each QoS profile that you add to the WAN QoS Profile
Table. You can bind these profiles to specified services by using the
QoS > Profile Binding page.
8
149