Static Dhcp - Cisco Small Business RV220W Administration Manual

Configuring Networking
LAN Configuration for IPv4
STEP 1
STEP 2
Cisco RV220W Administration Guide

Static DHCP

You can configure a static IP Address and MAC Address for a known computer or
device on the LAN network from the LAN Interface menu.
To open this page: In the navigation tree, choose Networking > LAN (Local
Network) > Static DHCP. Or from the Networking > LAN (Local Network) > IPv4
LAN (Local Network) page, click Configure Static DHCP.
Perform one of these tasks:
• To reserve a static IP address for a client, click Add. Then enter the settings,
as described below.
- IP Address—Enter the IP address of the device. This address should be
outside the DHCP address range specified on the Networking > LAN
(Local Network) > IPv4 LAN (Local Network) page. The DHCP server
will serve the reserved IP address only to the device with the
corresponding MAC address.
- MAC Address—Enter the MAC address of the device, without
punctuation. The punctuation is added automatically, using the following
format: XX:XX:XX:XX:XX:XX where X is a number from 0 to 9 (inclusive) or
an alphabetical letter between A and F (inclusive).
• To edit an entry, check the box and then click Edit. To select all entries, check
the box in the heading row. Then enter the settings, as described above.
• To delete an entry, check the box and then click Delete. To select all entries,
check the box in the heading row.
Click Save to save your settings, or click Cancel to reload the page with the
current settings. After saving or canceling, you can add, edit, or delete other
entries.
2
28