Connection Of Doorphone - Panasonic Easa-Phone VA-208 Installation Manual

Step 2
Step 3
Step 4
4a.
4b.
Step 5
Step 6
SYSTEM SETTINGS
LdNG SPEECH ALARM
Place TEL Station 1 in the programming mode by depressing the SPKR button.
Dial the feature program activation Code B p[ ' F]
Activate only one (1) of the following options:
To activate the LONG SPEECH ALARM, depress the SPKR button, if extinguished,
to light the LED lamp.
OR
To deactivate the LONG SPEECH ALARM, depress the SPKR button, if on, to
extinguish the LED lamp.
r%zJ-XJ
Depress the # button on the Dial Pad to store the program established in Step 4.
Proceed to next feature program OR to end programming, depress FLASH button and SPKR button in sequence.
CONNECTION OF DOORPHONE
This instruction is used to indicate whether a doorphone is connected. The Easa-Phone VA-208 System can be equipped
for a maximum of two doorphones.
0 The initial program setting is for a doorphone to be connected.
0 To change the program setting, perform the following steps:
Step 1
Step 2
Step 3
Step 4
4a.
Place the system in the programming mode. See instructions in the General Operational Procedures.
Place TEL Station
1
in the programming mode by depressing the SPKR button.
Dial the feature program activation Code pi F\ F\
Activate only one (1) of the following options:
To program a doorphone to be connected, depress the COL 1 button, if
extinguished, to light the LED lamp.
OR
4b. To program a doorphone to be disconnected, depress the COL 1 button, if on, to
extinguish the LED lamp.
Step 5 Depress the # button on the Dial Pad to store the program established in Step 4.
Step 6 Proceed to next feature program or to end programming, depress FLASH button and SPKR button i-" sequence.
Option
)
COL
1
Connected ( ON
30