Incoming Col Call Arriving Alarm - Panasonic Easa-Phone VA-208 Installation Manual

COL SETTINGS
' TYPE OF LINE
Step 4 Activate only one (1) of the following options:
4a. To set the TYPE OF LINE for a Central Office line, depress the SPKR button, if
on, to extinguish the LED lamp.
OR
4b. To set the TYPE OF LINE for a PBX line, depress the SPKR button, if extinguished,
to light the LED associated with the button.
Step 5
Depress the # button on the Dial Pad to store the program established in Step 4.
Option
I
SPKR
PBX 1 ON
Step 6
Proceed to next feature program or to end programming, depress FLASH button and SPKR button in sequence.
INCOMING COL CALL ARRIVING ALARM
This feature will generate an alarm sound at every Key Telephone when an incoming call on COL 1 and COL 2 is not answered
within the time frame set by the INCOMING ALARM.
NOTE: Only one COL can be programmed at a time. To change both COL 1 and COL 2, complete Steps 1 thru 5 for COL
1
and then repeat Steps 3 thru 5 for COL 2.
0 The initial program setting is for no alarm.
0 To change the program setting, perform the following steps:
Step 1
Step 2
Step 3
3a.
Step 4
4a.
4b.
Step 5
Step 6
Place the system in the programming mode. See instructions in the General Operational Procedures.
Place TEL Station 1 in the programming mode by depressing the SPKR button.
Dial the appropriate Feature Program Activation Code for the COL to be programmed
For COL l-Dial Feature Program Activation Code bl ' m m
For CoL 2-Dial Feature Program Activation Code I%] m x
Activate only one (1) of the following options:
To set the INCOMING COL CALL ARRIVING ALARM, depress the REDIAL button,
if extinguished, to light the INT LED lamp.
OR
To deactivate the INCOMING COL CALL ARRIVING ALARM, depress the REDIAL
button, if on, to extinguish the INT LED lamp.
Depress the # button on the Dial Pad to store the program established in Step 4.
Proceed to next feature program or to end programming, depress FLASH button and SPKR
button
insequence.
34