Intercom Call During Conversation - Panasonic Easa-Phone VA-208 Installation Manual

KEY TELEPHONE SETTINGS
DOORPHONE CALL
4c. To set the TEL Station to receive DOORPHONE A and DOORPHONE
S CALL, depress COL 1 and COL 2 buttons, if extinguished, to light
the LED lamps.
Option
j
COL
1 1
COL 2
DP NB
Conn. ON
1 of4
OR
4d. To set the TE.L Station to not receive a DOORPHONE CALL, depress
COL 1 and COL 2 buttons, if on, to extinguish the LED lamps.
Option
1 COL
1 1
COL 2
DPAIB Not Corm
1 OFF 1 OFF
Step 5
Depress the # button on the Dial Pad to store the program established in Step 4.
Step 6
Proceed to next feature program or to end programming, depress FLASH button and SPKR buttons in sequence.
INTERCOM CALL DURING CONVERSATION
This feature allows an intercom caller to signal a TEL Station which is already busy on an Intercom Call by superimposing
a continuous tone. Each TEL Station must be individually programmed for INTERCOM CALL DURING CONVERSATION.
NOTE: Only one TEL Station can be programmed at a time. To change the INTERCOM INCOMING CALL DURING
CONVERSATION on multiple TEL stations, complete Steps 1 thru 5 for the first TEL Station and then repeat Steps
3 thru 5 for each remaining TEL Station you wish to change.
l
The initial program setting is for all TEL Stations to have no INTERCOM INCOMING CALL DURING CONVERSATION.
0 To change the program setting, perform the following steps:
Step 1 Place the system in the programming mode. See instructions in the General Operational Procedures.
Step 2
Place TEL Station 1 in the programming mode by depressing the SPKR button.
Step 3
Dial the Feature Program Activation Code for the particular TEL Station to be programmed.
For TEL Station l-Dial Feature Program Activation Code m fl x
For TEL Station 2-Dial Feature Program Activation Code m p] E]
For TEL Station 3-Dial Feature Program Activation Code p] 131 d
For TEL Station 4-Dial Feature Program Activation Code m k] b]
For TEL Station S-Dial Feature Program Activation Code F] E] p]
For TEL Station 6-Dial Feature Program Activation Code m F] ]y]
For TEL Station 7-Dial Feature Program Activation Code
q
m k]
For TEL Station 8-Dial Feature Program Activation Code p] p] k]
38