Network Deployment - Vivotek SD7151 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Network deployment

Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to Internet connection.
1. If you have external devices such as sensors and alarms, make connection from general I/O
terminal block.
2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use Catagory 5 Cross Cable when Network Camera is directly connected to PC.
3. Connect the power cable from the Network Camera to a power outlet (AC 24V 2A).
1
There are several ways to setup the Network Camera over the Internet. The first way is to setup
the Network Camera behind a router. The second way is to utilize a static IP. The third way is to
use PPPoE.
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below.
1. Connect your Network Camera behind a router, the Internet environment is illustrated as
below. About how to get your IP address, please refer to Software installation on page 10 for
details.
8 - User's Manual
2 Ethernet switch
WAN (Wide Area Network )
Router IP address : from ISP
Internet
LAN (Local Area Network)
Router IP address : 192.168.0.1
Cable or DSL Modem
1
3
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
GND: Ground
D I 4 : Digital Input
D I 3 : Digital Input
D I 2 : Digital Input
D I 1 : Digital Input
GND: Ground
N.O. : RELAY_NO
COM. : RELAY_COM
+12V : Power, 12V DC