Desktop Remote Control - Garrett PD 6500i User Manual

PD 6500i User MANUAL
power jumper is an effective method to ensure that nearby units are properly connected to
the same power phase. To install, simply remove the rubber grommet in the top of the
detection housing and install in series with the power cord jumper. Each PD 6500i requires
less than two amperes of current and it is possible to safely connect five or more units to a
common electrical outlet.
8.3 Desktop Remote Control
PN 2266400
The desktop remote control allows the user to monitor and control the PD 6500i from a remote
location. The remote includes a full keypad, LCD Panel, LED bar graph, zone indications, and
audible alarm. A 50 foot cable is included as a standard length cable. Cables up to 200 feet are
available as a special order from the factory.
Installation requires access to the detection unit housing. Remove the rubber plug in the top
of the unit to allow the cable to feed into the housing. Remove the three screws that secure
the circuit board cover and connect the cable at the lower left corner of the pcb.
© 2008 Garrett Metal Detectors 51 PN 1532010 REV F1