Garrett PD 6500i User Manual page 31

3.5.27 reLAY
This feature enables the user to change the AC and DC relay circuits to "normally open"
(RELAY N/O) or "normally closed" (RELAY N/C) depending on the installation requirements.
RELAY, with either N/O or N/C, will appear on the LCD.
The user may use the + / - touchpads to change to N/O or N/C
.
3.5.28 OPerATOr eNABLe
This setting works in conjunction with the "Enable" or "Disable" key position at the Control
Panel. It allows the PD 6500i to further protect menu settings from tampering. Settings are as
follows on this table:
Operator enable
ON
OFF
ON w/Key
3.5.29 ALTer sUPervIsOr CODe (+ TO ALTer CODe 1)
The Supervisor Adjustments code (referred to as CODE 1) is factory preset to 1234. To
change it:
1. Press the + touchpad.
2. Enter a new four-digit code.
3. When the LCD prompts, REPEAT CODE, re-enter the new four-digit code. The message,
CODE ENTERED OK, should appear. (If the message, INVALID ENTRY, appears, repeat
steps 2 and 3.)
3.5.30 ALTer ADMINIsTrATOr CODe (+ TO ALTer CODe 2)
The Administrator Adjustments code (referred to as CODE 2) is factory preset to 5678. To
change it:
1. Press the + touchpad.
2. Enter a new four-digit code.
3. When the LCD prompts, REPEAT CODE, re-enter the new four-digit code. The message,
CODE ENTERED OK, should appear. (If the message, INVALID ENTRY, appears, repeat
steps 2 and 3.)
© 2008 Garrett Metal Detectors
PD 6500i User MANUAL
Key Position
enable
All touchpads are OPERATIONAL
All touchpads are blocked except
ON, OFF and ACCESS
All touchpads are OPERATIONAL
31
Disable
All touchpads are OPERATIONAL
except ACCESS
All touchpads are BLOCKED
All touchpads are BLOCKED
PN 1532010 REV F1