Garrett PD 6500i User Manual page 18

PD 6500i User MANUAL
5. Determine the location of the AC power outlet and select a power connection means. If
power is to be supplied from an overhead source, remove the rubber access plug in the
top of the detection unit, feed the power cord (or the 2' AC jumper cord if required) into the
detection unit and plug directly into the power module.
If power is to be supplied at floor level, determine the panel that is nearest the power
outlet. Within the Detection Unit, plug in the 2' AC jumper cord from the selected panel
to the power module. Retrieve the power cable at the bottom of the entrance side of the
selected panel through the 1½ inch diameter opening in the bottom of the boot. Slip the
power cord into the clamp, as shown in Figure 2-4, to prevent pinching and abrasion when
the unit is set upright. Secure the connection with electrical tape or other means if required.
NOTE: Wrap plugs with
electrical tape if needed.
Figure 2-4 Figure 2-5
6. Use the four remaining screws and washers to attach the crosspiece to the two panels.
(See Figure 2–5.)
7. If optional adhesive floor mounts are to be used, attach the mounting plates to side panels.
Do not remove adhesive protectors at this time. Follow instructions provided in the
mounting kit.
8. Use two or more people to lift the PD 6500i to a vertical position and move to desired location.
(See Figure 2–6, below.)
Figure 2-6
© 2008 Garrett Metal Detectors 18 PN 1532010 REV F1