Garrett PD 6500i User Manual page 10

1.3.1.6 TOUCHPADs
Use to turn unit on, access and adjust setup and programming. Function of touchpad
depends upon key lock and user access level.
1.3.1.6.1 OPERATE (ON / TEST)
The OPERATE touchpad is used to turn the PD 6500i on. The unit will be ready to operate
within ten seconds. Activate the manual self-test at any time by pressing OPERATE.
1.3.1.6.2 OFF
The OFF touchpad is used to turn the PD 6500i off, ensuring that all of the information and
settings are stored in memory until the detector is ready to resume full operation.
1.3.1.6.3 COUNTER
The COUNTER touchpad is used to obtain an automatic update on the traffic count that
appears on the LCD. The counter also reports alarm statistics such as alarm count and
alarm count %. If operator access is enabled, the counter may be reset by pressing the
COUNTER touchpad for approximately ten seconds.
1.3.1.6.4 VOLUME
The VOLUME touchpad is used to access the volume control of the audio alarm.
1.3.1.6.5 (+) and (–)
The plus (+) and minus (–) touchpads are used to change numerical settings, activate certain
on/off functions and adjust the volume of the audio alarm.
1.3.1.6.6 PROGRAM
The PROGRAM touchpad enables the user to view the current program and base
sensitivity settings on the LCD.
1.3.1.6.7 ACCESS
The ACCESS touchpad is used to initiate the log-in process and to scroll through menu
items.
1.3.1.7 PACING LIGHTs
Pacing lights located on side panels of the entrance side indicate whether or not a patron
may enter the walk-through. The green "proceed" ( ) symbol indicates the unit is ready for
a patron, while the red "wait" (
1-2.)
© 2008 Garrett Metal Detectors
PD 6500i User MANUAL
) symbol indicates the patron should wait. (See Figure
10 PN 1532010 REV F1