Socket 7X User Manual page 35

To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the
trigger button. An aiming beam will appear for 3 seconds. Keep your hand
steady while scanning.
For example, try scanning the following barcode:
After data is read and sent to the computer, by default, the CHS will beep
once and vibrate, the LED will flash green, and the beam will turn off.
By default, a carriage return is applied after scanned barcode data is
entered. To disable the automatic carriage return, you can use the
Command Barcodes
If no data is read in a few seconds, the beam will turn off, and you must try
again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3
seconds, until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it
paired and connected to. Make sure your computer is in range with Bluetooth enabled.
If the CHS is connected to your computer and gets disconnected, it will try to reconnect
for a few minutes. Make sure the computer is on and in range. If the CHS cannot
reconnect, it will emit a long beep. Press the trigger button to restart the reconnection
process.
See Appendix F
CHAPTER 4: SETUP FOR WINDOWS MOBILE
(use the Data Editing barcode for Data As Is).
for unpairing instructions.
35