Table of Contents
Advertisement
O
1: U
PTION
SING THE
To pair the CHS with your computer:
You only need to pair the CHS with you computer the first time you try to connect.
1. Power on the CHS. Press and hold the small power button until the LED turns blue and
the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on but not
connected.
2. Scan this barcode to configure the CHS for HID mode for peripherals. Afterwards, the
CHS will beep 3 times.
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
By default, the CHS is in HID Keyboard mode. If the CHS was changed to SPP mode,
first use the
Command Barcodes
the barcode above.
3. Turn on Bluetooth
instructions.
4. Use you computer's Bluetooth software to connect to the CHS (see instructions on next
page).
In the device search, the CHS will appear as Socket CHS [xxxxxx]. The characters in
brackets are the last six characters of the CHS Bluetooth Device Address (BDA),
which is labeled inside the battery compartment.
To identify your type of Bluetooth stack, click Start. Right-click on My Computer
and click Properties | Hardware tab | Device Manager and identify the
manufacturer of your Bluetooth device.
CHAPTER 3: SETUP FOR WINDOWS PC
CHS
HID M
IN
ODE
to change the CHS to HID mode before scanning
on your computer. Refer to your computer's documentation for
15
Advertisement
Table of Contents
