Nokia IP200 Series Installation Manual page 79

defaults from the binary file. To set the boot manager to defaults, issue the
set-defaults command at the boot manager prompt as shown in this example:
BOOTMGR> set-defaults
If you issue the printenv command again, the boot-file and boot-device entries
are present, as shown in this example:
Issue the halt command to restart your appliance:
Nokia IP200 Series Security Platform Installation Guide
BOOTMGR[2]> printenv
BOOTMGR[93]> printenv
NOKIA IPSO BOOTMGR VERSION=3.8 09.05.2003-130000
autoboot: YES
testboot: NO
bootwait: 3
boot-file: /image/current/kernel
boot-flags:
boot-device: wd0
vendor: Nokia
model: IP
bmslice: 4
BOOTMGR> halt
Troubleshooting
79