Impex MARCY DIAMOND MD-8870 Owner's Manual page 20

STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Draw the 122" Cable (#62) through the opening on Foot Plate (#35) to the opening on
bottom of Middle Vertical Frame (#8).
B.) Attach a Pulley (#39) to the opening. Secure it with one M10 x 2 3/8" Allen Bolt (#74), two Ø
1" x ½" Pulley Bushings (#37), and one M10 Aircraft Nut (#83).
C.) Draw the Cable under the Pulley and then to the open bracket on Lower Pulley Frame (#15).
D.) Attach a Pulley to the bracket. Secure it with one M10 x 2" Allen Bolt (#75), two Ø ¾"
Washers (#81), two Cable Retainers (#59), and one M10 Aircraft Nut (#83).
E.) Draw the Cable around the Pulley and then upward to the Double Floating Pulley Brackets
(#23) previously installed in Step-5.
F.) Repeat D to install a Pulley to the selected holes on Double Floating Pulley Brackets.
G.) Draw the Cable around the Pulley then downward to the open bracket on Middle Vertical
Frame. Repeat D to install a Pulley.
H.) Draw the Cable around the Pulley then upward to the Single Floating Pulley Bracket (#24)
installed in Step-6. Secure the end of Cable to the Bracket with one M10 x 1" Allen Bolt
(#73), two Ø ¾" Washers (#81), and one M10 Aircraft Nut (#83).
I.) Move the lower Pulley position on the Double Floating Pulley Brackets will adjust the tension
of the whole Cable system. Move up the Pulley will increase the tension. Move down the
Pulley will loosen the tension.
J.) Attach the Shiver Bar (#31) to the Cable with one 15-link Chain (#52) and two Hooks (#54).
Replace the Shiver Bar with Ankle Strap (#56) or Single Handle (#65) for various exercises.
19