Impex MARCY DIAMOND MD-8870 Owner's Manual page 13

STEP 4 (See Diagram 4)
A.) Slide the Sliding Weight Post (#22) onto the Weight Glide Post (#16). The triangular
bracket on Sliding Weight Post needs to be behind the Weight Glide Post and facing
upward.
B.) Attach the Weight Glide Post to the Lat Bar Frame (#17). Attach one 3 1/8" x 1 ¾" Bracket
(#29) to the Weight Glide Post. Secure the upper hole with one M10 x 2 ½" Allen Bolt (#88)
and one Ø ¾" Washer (#81). Secure the lower hole with one M10 x 2 ½" Carriage Bolt
(#67), one Ø ¾" Washer (#81), and one M10 Aircraft Nut (#83).
C.) Attach the Weight Glide Post to the Lower Pulley Frame (#15). Attach one 3 1/8" x 1 ¾"
Bracket (#29) to the Weight Glide Post. Secure the upper hole with one M10 x 2 ½"
Carriage Bolt (#67), one Ø ¾" Washer (#81), and one M10 Aircraft Nut (#83). Secure the
lower hole with one M10 x 2 ½" Allen Bolt (#88) and one Ø ¾" Washer (#81).
D.) Securely tighten all Nuts and Bolts installed in Step-1, Step-2, Step-3, and Step-4.
E.) Attach the Butterfly Base (#10) to front Middle Vertical Frame. Attach the Butterfly Pulley
Bracket (#13) to the Middle Vertical Frame from rear. Secure them together with two M10 x
2 ½" Carriage Bolts (#67), two Ø ¾" Washers (#81), and two M10 Aircraft Nuts (#83).
F.) Attach the Butterfly Stopper (#60) to Butterfly Base. Secure it with two M6 x 3/8" Allen Bolts
(#78).
G.) Attach two Swivel Pulley Brackets (#14) to the Butterfly Pulley Bracket. Secure each with
one M12 x 4 7/8" Hex Bolt (#79), one Ø 1" Washer (#82), and one M12 Aircraft Nut (#84).
H.) Insert the pivot one Left Butterfly (#11) to the Butterfly Base from bottom. Secure it with one
M10 x 5/8" Allen Bolt (#71) one Ø ¾" Washer (#81), and one Lock Ring (#28). Push a
Butterfly Foam Roll (#40) to Left Butterfly.
I.) Repeat H to install the Right Butterfly (#12).
J.) Attach the Backrest Board (#34) to Middle Vertical Frame. Secure it with two M8 x 2 3/8"
Allen Bolts (#77) and two Ø 5/8" Washers (#80).
K.) Attach two Olympic Sleeves (#49) to the Sliding Weight Post. Attach a Spring Clip (#50) to
each Olympic Sleeve.
12