Selecting And Adjusting A Camera Or Other Video Source - Polycom RealPresence Group 700 system User Manual

User's Guide for the Polycom RealPresence Group Series

Selecting and Adjusting a Camera or Other Video Source

10
You can use the remote control to select and adjust the main camera or other
near-end or far-end video sources, such as document cameras or computers.
You may be able to adjust other auxiliary cameras or far-end cameras that
support pan, tilt, and zoom movement. You can adjust the far-end camera only
if it is configured at the far end to allow you to control it.
When you are in camera control mode, you can press and hold a number to
save a preset. For more information about presets, see
Camera Presets on page 13.
To select a near-end or far-end camera, or other video source:
Out of a call:
• Using your remote control, go to
select the camera or other video source you want to use from the list.
In a call:
• Select > Cameras. Then select Your Cameras for near-end control or
Their Cameras for far-end control.
• To switch between Your Cameras and Their Cameras without accessing
the menu, press Select on the remote control while in a call.
To return to a previous screen after adjusting your or their camera settings,
select .
To adjust a Polycom EagleEye HD, Polycom EagleEye II, Polycom EagleEye
Acoustic, Polycom EagleEye 1080, Polycom EagleEye View, Polycom
EagleEye Director or Polycom EagleEye III using the remote control:
1 Select either a near-end or far-end video source to control. During a
multipoint call being hosted by a system in the call, you can only adjust a
camera at the far end that has a current speaker.
If you are using an EagleEye Director and camera tracking is on, you must turn
camera tracking off before adjusting the camera.
2 Press the navigation buttons on the remote control to move the camera
up, down, left, or right.
3 On the remote control, press
Setting and Using
> Cameras > Select Camera. Then
to zoom out or to zoom in.
Polycom, Inc.