Connectors, & Slots - Albatron K8X250GB PRO Manual

2.4 C
ONNECTORS
Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.
Hard Disk Connectors: IDE1~2
The motherboard has a 32-bit Enhanced PCI IDE Controller that provides
PIO Mode 0~5, Bus Master, and Ultra DMA 33/66/100/133 functionality. It
has two HDD connectors IDE1 (primary) and IDE2 (secondary).
The IDE connectors can connect a master and a slave drive, so you can
connect up to four hard disk drives. The first hard drive should always be
connected to IDE1.
Peripheral Component Interconnect Slots: PCI1~5
This motherboard is equipped with 1 standard PCI slot. PCI stands for
Peripheral Component Interconnect, and it is a bus standard for expansion
cards. This PCI slot is designated as 32 bits.
Serial ATA Connector: JSATA4~5
The motherboard has a SATA Controller in nForce 3 250Gb with 2 channels
SATA interface, it satisfies the SATA 1.0 spec and with transfer rate of
150MB/s.
1
7
JSATA4/JSATA5
, & S
LOTS
Pin Assignment
1 Ground
3 TX-
5 RX-
7 Ground
10
K 8 X 2 5 0 G B
K 8 X 2 5 0 G B
Pin Assignment
2 TX+
4 Ground
6 RX+
P R O
P R O