Maintenance - ProForm 390 E User Manual

MAINTENANCE AND TROUBLESHOOTING
_nspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap IMPORTANT: To avoid
damage to the console, keep liquids away from
the console end keep the console out of direct
sunlight.
CONSOLE TROUB LES HOOTING
if the console displays become dim, the batteries
should be replaced; most console problems are the
resutl of tow batteries.. See assembly step 6 on page 8
for replacemeni inslructions.
If the handgrip pulse sensor does not function prop-
edy, see step 5 on page t6.
HOW TO ADJUST THE DRIVE BELT
tf you can feel ll_e pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjustedr
To adjust the drive belt, you must remove the left
pedal, the lop shield cover, the rear shield cover, and
the left shield.
First, see step 15 on page t3 and remove the left
pedal
Nexl, see step 16 on page 13 and remove lhe rear
shield cover,
Then. see step 4 on page 7 and release the top shield
cover from the left shield Slide the top shield cover
upward.
Remove the M4 x 16mm Screws (92) from the Left
Shield (44) and then gently move the Left Shietd out-
ward over the Left Pedal Arm (t4)-
44
92
92
Next, loosen the Pivol Screw (88) Then, tighten the
Drive Belt Adjustmenl Screw (72) until the Drive Bait
(46) is tight.
When the Drive Belt (46) is light, tighten the Pivof
Screw (Be),
Then, reattach the left shield, the rear shield cover, the
top shield cover, and the left pedal.
18