Switching Off And Winding Up The Power Cable - Dirt Devil Vision V1 Operating Manual

3 Operating
3.2 Switching off and
winding up the power
cable
1
2
3
30
3. Operate the pedal switch (Fig. 13/1) to release the
brushing foot. You can now move the handle
backwards and forwards.
1
4. Switch on the brush vacuum cleaner using the on/off
switch (Fig. 14/1).
5. To vacuum, push the brush vacuum cleaner back and
forth. When vacuuming, observe the corresponding
recommendations of the flooring manufacturer.
Fig.13
NOTE:
The brushing roller on your Vision V1 brushes the dirt out
of the carpet and therefore cleans your carpet flooring
1
particularly thoroughly. Set the pile depth adjustment
according to your type of flooring to achieve an optimum
cleaning result.
Fig.14
1. Switch off the brush vacuum cleaner using the on/off
switch (Fig. 14/1) and pull the plug out of the socket.
2. If necessary, push the telescopic tube (Fig. 15/1) into
the telescopic tube mount (Fig. 15/2), until it audibly
clicks into place.
3. Put the appliance into idle running mode. To do this,
move the handle (Fig. 15/1) forwards until it audibly
clicks into place and turn the control switch for setting
the pile depth entirely to the right (Fig. 11/2).
4. Secure the flexible suction hose to the suction hose
mounts (Fig. 8/1).
Fig.15
5. Wind the mains cable onto the cable mounts (Fig. 16/1).
6. Turn the pile depth adjustment entirely to the right
(Fig. 14/2).
1
Fig.16