Dirt Devil Vision V1 Operating Manual page 35

5 Maintenance
1
1
2
1
2
1
7. Carefully remove the brushing foot cover (Fig. 28/1).
Fig.28
8. Lift the V-belt cover (Fig. 29/1) up out of the brushing
foot.
Fig.29
9. Pull the housing (Fig. 30/1) out a bit and lift the right side
4
of the brushing roller (Fig. 30/2). Then lift the brushing
roller out of the brushing foot.
10. First lift the V-belt (Fig. 30/3) off the drive axle
(Fig. 30/4) and then off the brushing roller (Fig. 30/2).
3
11. If necessary, remove any V-belt remains.
12. Assemble the new V-belt (Order Number, ZChapter 9,
"Spare parts"). First push it over the drive axle
(Fig. 30/4) and then over the belt guide on the brushing
Fig.30
roller (Fig. 31/1).
13. Reinsert the brushing roller, first the left side (Fig. 31/2)
and then the right (Fig. 31/1).
14. Put the V-belt cover (Fig. 29/1) back into the brushing
foot.
15. Assemble the brushing foot cover (Fig. 28/1).
16. Turn the appliance around.
17. Secure the 5 fastening screws on the brushing foot
Fig.31
cover (Fig. 28/1).
18. Replace the base plate (Fig. 26/1).
19. Assemble the hinge covers (Fig. 25/1) with four screws
(Fig. 25).
35