Table of Contents
Advertisement
4300 Wood Stove Series (ACC)
G. Building A Fire
Before lighting your first fire in the stove:
1. Confirm the baffle is correctly positioned. It should be
even with the front tube and resting on all tubes. Figure
28.1.
2. Follow instructions on page 32 for cleaning plated sur-
faces, if applicable.
.
Remove all labels from glass.
There are many ways to build a fire. The basic principle
is to light easily-ignitable tinder or paper, which ignites the
fast burning kindling, which in turn ignites the slow-burning
firewood. Here is one method that works well:
1. Open the Burn Rate Air and Start-Up Air Controls fully.
2. Place several wads of crushed paper on the firebox floor.
Heating the flue with slightly crumpled newspaper before
adding kindling keeps smoke to a minimum.
. Lay small dry sticks of kindling on top of the paper.
4. Make sure that no matches or other combustibles are in
the immediate area of the appliance. Be sure the room
is adequately ventilated and the flue unobstructed.
5. Light the paper in the appliance. NEVER light or rekindle
fire with kerosene, gasoline, or charcoal lighter fluid; the
results can be fatal.
6. Once the kindling is burning quickly, add several full-
length logs inches (76mm) or 4 inches (102mm) in
diameter. Be careful not to smother the fire. Stack the
pieces of wood carefully; near enough to keep each
other hot, but far enough away from each other to allow
adequate air flow between them.
7. Set the Burn Rate Air Control and activate the timer
system (ACC).
8. When ready to reload, It is best to fully open both the
Burn Rate Air and Start-up Air Controls before reload-
ing. This livens up the coalbed and reduces excessive
emissions (opacity/smoke). Open door slowly so that
ash or smoke does not exit appliance through opening.
Large logs burn slowly, holding a fire longer. Small logs
burn fast and hot, giving quick heat.
9. As long as there are hot coals, repeating steps 6
through 8 will maintain a continuous fire throughout the
season.
NOTE:
• Build fire on brick firebox floor.
• Do NOT use grates, andirons or other methods to support
fuel.
It will adversely affect emissions.
Page 28
Baffle Board even with front
tube & resting on all tubes
Ceramic Blanket on Top
Tube Channels
Figure 28.1
Fire Risk
Do NOT store wood:
• Closer than required clearances to com-
• Within space required for loading or ash
Do NOT operate appliance:
• With appliance door open.
• With ash removal system door open.
Fire Risk.
•
Do NOT burn wet or green wood.
•
Store wood in dry location.
•
Stack wood so both ends are exposed to air.
Wet, unseasoned wood can cause accumulation of
creosote.
7037-135E
Burn Rate
Air Control
Start-Up
Air
Control
2 pc Baffle Board
WARNING
bustibles to appliance
removal.
WARNING
September 1, 2008
R
Advertisement
Table of Contents
