Call Service - ATCOM AT-620P User Manual

AT-620P User Manual
SIP STUN is used for NAT transverse. When you config STUN server's
address and port (default 3478) and enable it, then you can use the normal
SIP server to make the IP phone transverse NAT.

Call Service

4.8.
Hotline: configure hotline number. AT-620P immediately dials this number
after hook-off if it is set and the user can not dial any other number.
No Answer Time: no answer call forward time setting.
No Disturb: DND, do not disturb, when there is an incoming call , the caller
will get the message that this line is not available , but you it has no
affection when you make outgoing call.
Ban Outgoing: Enable this to ban outgoing calls.
Enable Call Transfer: Enable Call Transfer by selecting it.
Enable Call Waiting: Enable Call Waiting by selecting it.
Enable Three Way Call: 3 way conference call.
Accept Any Call: If select it, the phone will accept the call even if the
called number is not belong to the phone.
Auto Answer: If select it, the phone will auto answer when there is an
incoming call.
P2P IP Prefix: Set Prefix in peer to peer IP call. For example: what you want to
dial is 192.168.1.119, If you define P2P IP Prefix as 192.168.1., you dial only
#119 to reach 192.168.1.119. Default is ".". If there is no "." Set, it means to
disable dialing IP.
Voicemail Number: Set the voicemail number for each line.
Black List: Set Add/Delete Black list , incoming call in these phone
numbers will be refused.
It support below rules,
You add a certain number in it , when this number call you , it will be
ATCOM TECHNOLOGY CO., LIMITED