Removing The Ignitor, Flame Sensor, High-Limit Thermostat; And Thermal Cutoff (Gas Models Only) - Whirlpool Duet Sport WED8300SW Manual

REMOVING THE IGNITOR, FLAME SENSOR, HIGH-LIMIT
THERMOSTAT, AND THERMAL CUTOFF
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the toe panel from the dryer (see
page 4-8 for the procedure).
4. To remove the ignitor:
a) Disconnect the ignitor wire connector
from the main harness (see the top
right photo).
b) Remove the 5/16˝ hex-head ignitor
bracket screw from the burner venturi
and remove the ignitor and bracket.
(GAS MODELS ONLY)
Gas Burner Assembly
Ignitor Bracket
Screw
c) Remove the 5/16˝ hex-head ignitor
screw and remove the ignitor from the
bracket.
4-14
Ignitor Connector
Ignitor Screw