Removing The Moisture Sensor - Whirlpool Duet Sport WED8300SW Manual

REMOVING THE MOISTURE SENSOR

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Open the dryer door, remove the lint fil-
ter, and close the door.
4. Remove the two screws from the outlet
grille.
Lint Filter
Outlet Grille Screws
5. From inside the drum, remove the three
screws from the outlet grille.
Screw
Moisture Sensor
6. Pull the moisture sensor away from the
dryer and disconnect the black and yel-
low-red wires from the moisture sensor
terminals.
Yellow-Red Wire
4-6
Outlet Grille
Screw
Black Wire
Screw