Whirlpool Duet Sport WED8300SW Manual page 86

10. If moisture sensor diagnostic test passes,
check the thermistor: Perform TEST #3a.
• If the problem persists after replacing the
moisture sensor and thermistor, replace
the machine control electronics.
TEST #4a Adjusting Customer-Focused
Drying Modes
NOTE: If the customer is complaining about
the clothes being damp and the moisture
sensor passes TEST #4 "Moisture Sensor
Test" step 3, the total dry time for an automatic
cycle can be lengthened by changing from a
"1" or standard auto cycle to a "2" or "3" longer
auto cycle.
1. Activate the diagnostic test mode, and
advance past saved fault codes.
2. In diagnostic test mode, press and hold the
Dryness button for 5 seconds. The dryer
will beep and the current drying mode will
be seen on the display. The factory default
value is "1".
3. To select a different drying mode, press the
Dryness button again. The dryer display
will flash and show 2, 3, or 1.
4. With the display flashing the selected
drying mode, press the START button to
save the drying mode and exit diagnostics
(the START button in this mode does not
start a drying cycle). The result will be
stored in EEPROM of the control board,
and will be retained after a power loss.
5. Press the PAUSE/CANCEL button at any
time to cancel changes and exit from this
mode.
TEST #5 Button and Indicator Test
This test is performed when any of the following
situations occurs during the Console Buttons
and Indicators Diagnostic Test:
• None of the indicators light up
• No beep sound is heard
• Some buttons do not light indicators
None of the indicators light up:
1. See Diagnostic Guide/Before Servicing.
2. Perform Test #1 to verify supply connect-
ions.
3. Perform steps in Accessing and Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control
electronics.
4. Visually check that the console electronics
and housing assembly is properly inserted
into the front console.
5. If both visual checks pass, replace
the console electronics and housing
assembly.
6. Plug in dryer or reconnect power.
7. Perform the Console Buttons and Indicators
Diagnostic test to verify repair.
8. If indicators still do not light, the machine
control electronics has failed:
• Unplug dryer or disconnect power.
• Replace the machine control electronics.
• Plug in dryer or reconnect power.
• Perform the Console Buttons and Indica-
tors Diagnostic test to verify repair.
No beep sound is heard:
1. Perform steps in Accessing and Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control
electronics.
• If visual check passes, replace the con-
sole electronics and housing assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indicators
Diagnostic test to verify repair.
6-14