Whirlpool Duet Sport WED8300SW Manual page 88

ACCESSING THE MACHINE
CONTROL ELECTRONICS
1. After locating the machine control electron-
ics, remove the two screws that hold the
machine control electronics bracket in place.
2. Slide the bracket over the top of the drum
to access the machine control electronics
connectors and mounting screw. See Fig-
ure 16.
REMOVING THE MACHINE
CONTROL ELECTRONICS
1. Remove all the wire connections to the ma-
chine control electronics. See Figure 17.
Machine Control
Electronics
Assembly
Machine Control
Electronics
Mounting
Bracket
Screw
Figure 16. Remove machine control
electronics from mounting bracket.
Heater
N.O. COM
Relay 1
Black Red
FRONT
Heater Relay 2
2. Remove the screw holding the machine
control electronics assembly to the mount-
ing bracket. See Figure 16.
3. There are two plastic legs on the front of
the machine control electronics that slide
under the mounting bracket. There is one
plastic leg on the rear of the machine control
electronics that slides under the mounting
bracket. There is a locking tab on the
bottom of the machine control electronics
that snaps into the mounting bracket.
Press the locking tab on the bottom of the
machine control electronics and slide the
assembly to the front, then lift.
Motor
Lt. Blue Black
Relay
P9
1
5
Black-White
Tan
White
Green-Yellow
1
P8 Open
Figure 17. Machine control electronics.
6-16
Yellow-Red
1
1
P13
P3
P5
8
1
P2
3
P14
1
Red-White
Open 6
3
P4
1
1
Open (Elec.)
Orange (Gas)
Red-White