Whirlpool Duet Sport WED8300SW Manual page 17

4-wire connection: Power supply cord
IMPORTANT: A 4-wire connection is required
for mobile homes and where local codes do
not permit the use of 3-wire connections.
B
A
C D
A. 4-wire receptacle (NEMA type 14-30R)
B. 4-prong plug
C. Ground prong
D. Neutral prong
E. Spade terminals with upturned ends
F. ¾" (1.9 cm) UL listed strain relief
G. Ring terminals
1. Remove center silver-colored terminal
block screw.
2. Remove neutral ground wire from external
ground conductor screw. Connect neutral
ground wire and the neutral wire (white or
center wire) of power supply cord under
center, silver-colored terminal block screw.
Tighten screw.
A
B
A. External ground conductor screw - Dotted line shows
position of NEUTRAL ground wire before being moved to
center silver-colored terminal block screw
B. Center silver-colored terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. ¾" (1.9 cm) UL listed strain relief
F
E
G
C
D
E
2-9
3. Connect ground wire (green or bare) of
power supply cord to external ground con-
ductor screw. Tighten screw.
A
B
C
A. External ground conductor screw
B. Ground wire (green or bare) of power supply cord
³⁄
C. " (1.9 cm) UL listed strain relief
4
D. Center silver-colored terminal block screw
E. Neutral ground wire
F. Neutral wire (white or center wire)
4. Connect the other wires to outer terminal
block screws. Tighten screws.
5. Tighten strain relief screws.
6. Insert tab of terminal block cover into slot
of dryer rear panel. Secure cover with
hold-down screw.
7. You have completed your electrical con-
nection. Now go to "Venting Require-
ments."
D
E
F