Removing The Inner Oven Glass - Whirlpool SELF-CLEANING SLIDE-IN GAS RANGES Manual

REMOVING THE INNER OVEN GLASS

1. Remove the door glass and the outer oven
glass, as instructed on pages 4-22 through
4-24, then proceed with the following steps.
Refer to Figure 4-21 for the following steps.
2. Position the oven door with the inner oven
glass facing up.
3. Remove the two bottom screws from the
right hinge, then lift the bottom of the hinge
assembly and unhook the top tab from the
slot in the panel, and remove the hinge.
4. Lift the right side of the inner door panel.
Slide the panel out from under the lip at the
bottom of the door, and from under the
three tabs on the left hinge assembly, and
remove the panel.
5. Remove the door insulation blanket.
6. Lift the inner oven glass and frame assem-
bly off the door.
Left Hinge
Assembly
Tabs
Insulation
Blanket
Inner Door Panel
Fiberglass
Gasket
Inner Oven Glass & Frame
Slide Inner Door Panel
Under Lip In Outer Door Frame
Figure 4-21
7. If you are replacing the fiberglass gasket
from around the window opening in the
door, remove and replace it at this time.
8. Install the new inner oven glass over the
fiberglass gasket.
9. Reassemble the oven door.
10. Reinstall the oven door on the range as
follows:
a) Grasp the door by the sides, and slide
the two door hinges into the tracks in
the range slots as far as the stop.
b) Pull the oven door open to the first
(broil) stop.
c) Lift the door straight up, and push in
until the hinges are over the stop and
are fully in place.
d) Close the oven door.
OUTER DOOR FRAME
Hinge Screws
4-25
Insert Tab
Through Slot
Right Hinge
Assembly
Tabs