Removing An Inner Door Glass - Whirlpool ESTATE TES325E W Service Manual

REMOVING AN INNER DOOR GLASS

WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electrical
shock.
CAUTION: When you work on the electric range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Turn off the electrical supply to the range.
2. Remove the oven door (see page 1-14 for the
procedure).
3. Remove the door handle, top trim, and outer
door glass from the oven door (see page
3-25).
4. Remove the three screws from the bottom
trim (see the inset on page 3-27) and remove
the bottom and side trim from the oven door.
5. Remove one of the hinge assemblies from the
oven door (see page 3-26).
6. Lift the side of the insulation retainer and slide
it out from under the remaining hinge assem-
bly.
7. Fold back the door insulation, remove the
defective inner door glass and frame from the
door liner.
8. If you are replacing the window seal, (the
rope-type seal around the metal frame), re-
move and replace it at this time. NOTE: Join
the rope ends at either top corner of the metal
frame.
9. Install the new inner door glass in the metal
frame.
INNER
DOOR
GLASS
10. Position the insulation around the metal frame.
11. Reinstall the insulation retainer in the door so
the edge is under the hinge assembly.
12. Position the arm on the hinge assembly to be
installed to the "broil stop" position, then mount
it to the oven door with its two screws. Make
sure that the tab at the top of the hinge fits into
the slot in the door liner before you mount the
screws.
13. Mount the bottom and side trim to the oven
door.
14. Mount the outer door glass, the top trim, and
the door handle to the door.
15. Using the bottom of your shoe, press down on
the hinge assembly arm, and insert the pin
into the hole in the arm.
16. Reinstall the oven door on the range.
3-28
METAL
FRAME
DOOR
LINER