Removing The Gas Pressure Regulator & Safety Valve - Whirlpool SELF-CLEANING SLIDE-IN GAS RANGES Manual

REMOVING THE GAS PRESSURE REGULATOR
WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, electri-
cal shock, or explosion.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Turn off the gas supply and electrical
power to the range.
& SAFETY VALVE
2.
Refer to Figure 4-15 for the following steps.
3.
4.
5.
4-20
Pull the range out from the cabinet far
enough to access the back panel.
Remove the four mounting panel screws,
the single pressure regulator screw, and
the four safety valve screws, then remove
the panel and set it aside.
Remove the three gas lines going to the
pressure regulator and the safety valve.
Remove the four wire connectors from the
safety valve and remove the pressure
regulator and the safety valve. NOTE: The
pressure regulator and the safety valve
are serviced as one assembly.